LED indications
LED off
LED blinking
LED on
LEDs | Description |
|---|---|
 | On / Off / Charger-only switch = On The inverter is switched on and supplies power to the load. |
 | On / Off / Charger-only switch = On The inverter is switched on and supplies power to the load. Pre alarm: overload, or battery voltage low, or inverter temperature high. |
 | On / Off / Charger-only switch = On The inverter is switched off due to one of the following alarms: overload, battery voltage low, inverter temperature high, or DC ripple voltage too high. |
 | On / Off / Charger-only switch = On The AC input voltage is switched through, and the charger operates in float mode. |
 | On / Off / Charger-only switch = On The AC input is switched through and the charge current is zero. The inverter is switched on and, in case of PowerAssist, assists the AC input by supplying additional power to the load the General chapter. |
 | On / Off / Charger-only switch = On The AC input voltage is switched through. The inverter is switched on and supplies power to the load or excess power to the mains. |
 | On / Off / Charger-only switch = Charger only The AC input voltage is switched through, and the charger operates in bulk or absorption mode. |
 | On / Off / Charger-only switch = Charger only The AC input is switched through, and the charger operates in float or storage mode. |
Note: The inverter/charger will shut down if four abnormal events occur within 30 seconds. It can be reset by switching to Off and then to On again.
For the latest and most up-to-date information about the blink codes, please refer to the Victron Toolkit app. Scan the QR code or click on the below link to go to the Victron software downloads webpage. https://www.victronenergy.com/support-and-downloads/software |  |