Differences

This shows you the differences between two versions of the page.

--- ve.can:nmea-2000:start [2017-02-02 17:06] – [5. FAQ] mvader
+++ ve.can:nmea-2000:start [2019-12-17 08:56] – [5. FAQ] evandromr
@@ Line 47: / Line 47: @@
   * Lynx Shunt Battery Monitors
   * Lynx Ion + Shunt all models
-  * BlueSolar MPPT Solar Chargers with VE.Can communications port
+  * SmartSolar MPPT Solar Chargers with VE.Can communications port
 {{ :ve.can:nmea-2000:schema_nmea2000-vecan_mppt-skylla_nov_2016.png?nolink&700 |}}
@@ Line 87: / Line 87: @@
 === Q2: Can MPPT Solar Chargers with a VE.Direct port also be connected? ===
-No, they cannot be connected. Even though the [[https://www.victronenergy.com/accessories/ve-direct-to-nmea2000-interface|VE.Direct to NMEA 2000 interface]] can be physically connected to these solar chargers, it will not work. Use our [[https://www.victronenergy.com/solar-charge-controllers/mppt-150-70|Solar Chargers with a VE.Can port]] instead.
+No, they cannot be connected. Even though the [[https://www.victronenergy.com/accessories/ve-direct-to-nmea2000-interface|VE.Direct to NMEA 2000 interface]] can be physically connected to these solar chargers, it will not work. Use our [[https://www.victronenergy.com/solar-charge-controllers/smartsolar%20mppt%20ve.can|Solar Chargers with a VE.Can port]] instead.
 Note that there are many more generic frequently asked questions answered in the [[https://www.victronenergy.com/upload/documents/Whitepaper-Data-communication-with-Victron-Energy-products_EN.pdf|Data communication white paper]].
@@ Line 93: / Line 93: @@
 === Q3: What about terminators and network layout? ===
-A N2K canbus network needs to be laid out as in backbone configuration, using drop cables to connect to each device. Also there should be only two terminators in the network. Therefore:
+A N2K CAN bus network needs to be laid out as in backbone configuration, using drop cables to connect to each device. Also, there should be only two terminators in the network. Therefore:
-  * Use the NMEA2000 cable as the back bone.
+  * Use the NMEA2000 cable as the backbone.
   * Run a separate drop cable separately to each Victron device. The drop cable will be one of these three products:
     * [[https://www.victronenergy.com/accessories/ve-bus-to-nmea2000-interface|VE.Bus to NMEA 2000 interface]]
@@ Line 109: / Line 109: @@
   * Victron Battery monitor data
   * Victron BMS data
-  * Victron Tank sender data as well as tank sender data from other manufacturers. See chapter 1.2.7 in the [[ccgx:start|]].
+  * Victron Tank sender data as well as tank sender data from other manufacturers. See chapter 1.4.7 in the [[ccgx:start|]].
 === Q5: Can integration onto Raymarine displays also be done without Empirbus NXT? ===
 No.
+=== Q6: What about Maretron and other brand tank sensors on the Ccgx? ===
+See chapter 1.4.7 in the [[ccgx:start|]].
 ===== DISQUS =====
 ~~DISQUS~~