mppt-error-codes
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
mppt-error-codes [2020-07-12 10:50] – [Err 119 - Settings data lost] mvader | mppt-error-codes [2021-01-08 14:39] – [Err 21 - Current sensor issue] mvader | ||
---|---|---|---|
Line 53: | Line 53: | ||
The feature of this safety protection is to detect a shorted cell; and stop charging. | The feature of this safety protection is to detect a shorted cell; and stop charging. | ||
==== Err 21 - Current sensor issue ==== | ==== Err 21 - Current sensor issue ==== | ||
+ | |||
+ | The current measurement is out of range. | ||
+ | |||
+ | Disconnect all wires, and then reconnect all wires, to make restart the charger. Also, make sure the minus on the MPPT charge controller (PV minus/ | ||
This error will not auto-reset. | This error will not auto-reset. | ||
- | Disconnect all wires, and then reconnect all wires. Also, make sure the minus on the MPPT charge controller (PV minus/ | + | If the error remains, please contact your dealer, there might be a hardware defect. |
+ | |||
+ | ==== Err 24 - Fan failure ==== | ||
+ | |||
+ | This error indicates that the fan is powered | ||
+ | |||
+ | Please contact your dealer, there might be a hardware defect. | ||
- | If the error remains, please contact the dealer, there might be a hardware defect. | + | Applies to Skylla-IP44 & Skylla-IP65 chargers only. |
==== Err 26 - Terminal overheated ==== | ==== Err 26 - Terminal overheated ==== | ||
Power terminals overheated, check wiring, including the wiring type and type of strands, and/or fasten bolts if possible. | Power terminals overheated, check wiring, including the wiring type and type of strands, and/or fasten bolts if possible. |
mppt-error-codes.txt · Last modified: 2024-02-12 05:48 by guy_stewart