mppt-error-codes
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
mppt-error-codes [2020-01-17 12:09] – external edit 127.0.0.1 | mppt-error-codes [2020-02-04 10:54] – [Err 68 - Network misconfigured] tabreu | ||
---|---|---|---|
Line 128: | Line 128: | ||
Applies to SmartSolar MPPTs and SmartSolar MPPTs VE.Can. | Applies to SmartSolar MPPTs and SmartSolar MPPTs VE.Can. | ||
- | The typical reason for the error to show is that the charger is configured to operate in parallel using our [[https:// | + | The typical reason for the error to show is that the charger is configured to operate in parallel using our [[https:// |
+ | |||
+ | The error might be intermittent as the charger will always try to reset the fault. There is a 10 seconds delay to retry resetting the error in order for the error to be seen and broadcast to the interfaces. | ||
Resolution: disable the parallel operation by connecting VictronConnect, | Resolution: disable the parallel operation by connecting VictronConnect, | ||
Line 134: | Line 136: | ||
For SmartSolar MPPT VE.Can only, also make sure its not connected to a [[https:// | For SmartSolar MPPT VE.Can only, also make sure its not connected to a [[https:// | ||
- | Once the conflict is resolved the error will disappear and the charger will resume normal operation, | + | Once the conflict is resolved the error will disappear and the charger will resume normal operation, within a minute. |
mppt-error-codes.txt · Last modified: 2024-02-12 05:48 by guy_stewart