mppt-error-codes
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
mppt-error-codes [2019-11-30 10:10] – [Err 119 - Settings data lost] boekel | mppt-error-codes [2019-12-11 23:22] – [Err 2 - Battery voltage too high] mvader | ||
---|---|---|---|
Line 8: | Line 8: | ||
==== Err 2 - Battery voltage too high ==== | ==== Err 2 - Battery voltage too high ==== | ||
+ | |||
This error will auto-reset after the battery voltage has dropped. | This error will auto-reset after the battery voltage has dropped. | ||
This error can be due to other charging equipment connected to the battery or a fault in the charge controller. | This error can be due to other charging equipment connected to the battery or a fault in the charge controller. | ||
- | This error can also occur if the battery voltage is set to a lower voltage than the actual | + | This error can also occur if the battery voltage |
==== Err 3, Err 4 - Remote temperature sensor failure ==== | ==== Err 3, Err 4 - Remote temperature sensor failure ==== | ||
Check if the T-sense connector is properly connected to a remote temperature sensor. | Check if the T-sense connector is properly connected to a remote temperature sensor. |
mppt-error-codes.txt · Last modified: 2024-02-12 05:48 by guy_stewart