mppt-error-codes
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
mppt-error-codes [2019-11-08 14:43] – tabreu | mppt-error-codes [2019-12-11 23:22] – [Err 2 - Battery voltage too high] mvader | ||
---|---|---|---|
Line 8: | Line 8: | ||
==== Err 2 - Battery voltage too high ==== | ==== Err 2 - Battery voltage too high ==== | ||
+ | |||
This error will auto-reset after the battery voltage has dropped. | This error will auto-reset after the battery voltage has dropped. | ||
This error can be due to other charging equipment connected to the battery or a fault in the charge controller. | This error can be due to other charging equipment connected to the battery or a fault in the charge controller. | ||
- | This error can also occur if the battery voltage is set to a lower voltage than the actual | + | This error can also occur if the battery voltage |
==== Err 3, Err 4 - Remote temperature sensor failure ==== | ==== Err 3, Err 4 - Remote temperature sensor failure ==== | ||
Check if the T-sense connector is properly connected to a remote temperature sensor. | Check if the T-sense connector is properly connected to a remote temperature sensor. | ||
Line 148: | Line 149: | ||
This error will not auto-reset. To get it working again: | This error will not auto-reset. To get it working again: | ||
- | - First, restore it to factory defaults. | + | - First, restore it to factory defaults. |
- Disconnect the charge controller from all power-sources | - Disconnect the charge controller from all power-sources | ||
- wait 3 minutes, and power up again. | - wait 3 minutes, and power up again. |
mppt-error-codes.txt · Last modified: 2024-02-12 05:48 by guy_stewart