mppt-error-codes
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
mppt-error-codes [2019-07-05 06:43] – [Err 20 - Maximum Bulk-time exceeded] mvader | mppt-error-codes [2019-11-08 14:43] – tabreu | ||
---|---|---|---|
Line 68: | Line 68: | ||
Disconnect all wires, and then reconnect all wires. If the error persists the charge controller is probably faulty. | Disconnect all wires, and then reconnect all wires. If the error persists the charge controller is probably faulty. | ||
+ | |||
+ | Note that this error was introduced in v1.36. So when doing an update, it might look like the firmware update caused this issue; but it doesn' | ||
==== Err 33 - PV over-voltage ==== | ==== Err 33 - PV over-voltage ==== | ||
Line 121: | Line 123: | ||
Applies to SmartSolar MPPTs and SmartSolar MPPTs VE.Can. | Applies to SmartSolar MPPTs and SmartSolar MPPTs VE.Can. | ||
- | The typical reason for the error to show is that the charger is configured to operate in parallel using our [[https:// | + | The typical reason for the error to show is that the charger is configured to operate in parallel using our [[https:// |
Resolution: disable the parallel operation by connecting VictronConnect, | Resolution: disable the parallel operation by connecting VictronConnect, |
mppt-error-codes.txt · Last modified: 2024-02-12 05:48 by guy_stewart