mppt-error-codes
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
| mppt-error-codes [2019-01-22 10:16] – external edit 127.0.0.1 | mppt-error-codes [2019-05-06 13:46] – rvanzundert | ||
|---|---|---|---|
| Line 110: | Line 110: | ||
| Note that (solar-)chargers automatically configure themselves to be BMS-controlled when they are connected to one; either direct or via a Color Control GX or Venus GX. | Note that (solar-)chargers automatically configure themselves to be BMS-controlled when they are connected to one; either direct or via a Color Control GX or Venus GX. | ||
| + | |||
| + | ==== Err 68 - Network misconfigured ==== | ||
| + | |||
| + | The charger detects multiple conflicting network sources trying to take control of the charger. | ||
| + | |||
| + | All Smart Solar charger models: | ||
| + | |||
| + | * If the charger is connected to a Venus GX device that takes control of the charger (by sending Charge Voltage Limits to the unit), the charger cannot not be joined to a VE.Smart network as well. In VictronConnect go to settings " | ||
| + | |||
| + | VE.CAN Smart Solar chargers only: | ||
| + | |||
| + | * If the charger is connected via VE.CAN to a Venus GX device do not install a VE.Direct cable to a Venus GX device as well. Either disconnect the VE.CAN cable or the VE.Direct cable. | ||
| + | |||
| + | Once the conflict is resolved the error will disappear and the charger will resume normal operation, usually within a minute. | ||
| + | |||
| + | |||
| ==== Err 114 - CPU temperature too high ==== | ==== Err 114 - CPU temperature too high ==== | ||
mppt-error-codes.txt · Last modified: 2024-02-12 05:48 by guy_stewart