Differences

This shows you the differences between two versions of the page.

--- mppt-error-codes [2018-06-28 11:38] – [Err 18 - Controller over-current] rvanzundert
+++ mppt-error-codes [2019-05-06 13:46] – rvanzundert
@@ Line 58: / Line 58: @@
 This error will auto-reset.
+==== Err 28 - Power stage issue ====
+This error will not auto-reset.
+Disconnect all wires, and then reconnect all wires. If the error persists the charge controller is probably faulty.
 ==== Err 33 - PV over-voltage ====
@@ Line 104: / Line 110: @@
 Note that (solar-)chargers automatically configure themselves to be BMS-controlled when they are connected to one; either direct or via a Color Control GX or Venus GX.
+==== Err 68 - Network misconfigured ====
+The charger detects multiple conflicting network sources trying to take control of the charger.
+All Smart Solar charger models:
+  * If the charger is connected to a Venus GX device that takes control of the charger (by sending Charge Voltage Limits to the unit), the charger cannot not be joined to a VE.Smart network as well. In VictronConnect go to settings "VE.Smart networking" and choose "Leave network".
+VE.CAN Smart Solar chargers only:
+  * If the charger is connected via VE.CAN to a Venus GX device do not install a VE.Direct cable to a Venus GX device as well. Either disconnect the VE.CAN cable or the VE.Direct cable.
+Once the conflict is resolved the error will disappear and the charger will resume normal operation, usually within a minute.
 ==== Err 114 - CPU temperature too high ====
@@ Line 124: / Line 146: @@
   - wait 3 minutes, and power up again.
   - Reconfigure the charger.
 ===== DISQUS =====
 ~~DISQUS~~