Differences

This shows you the differences between two versions of the page.

--- mppt-error-codes [2018-05-09 10:27] – [Err 116 - Calibration data lost] rvanzundert
+++ mppt-error-codes [2019-01-21 11:20] – [DISQUS] ictbeheer
@@ Line 33: / Line 33: @@
 ==== Err 18 - Controller over-current ====
 This error will auto-reset.
-Disconnect the charge controller from all power-sources, wait 3 minutes, and power up again.
+If the error does not auto-reset disconnect the charge controller from all power-sources, wait 3 minutes, and power up again. If the error persists the charge controller is probably faulty.
-If the error persists the charge controller is probably faulty.
+A cause for this error can be switching on a very large load on the battery side.
 ==== Err 20 - Maximum Bulk-time exceeded ====
@@ Line 58: / Line 58: @@
 This error will auto-reset.
+==== Err 28 - Power stage issue ====
+This error will not auto-reset.
+Disconnect all wires, and then reconnect all wires. If the error persists the charge controller is probably faulty.
 ==== Err 33 - PV over-voltage ====
@@ Line 126: / Line 132: @@
-===== DISQUS =====
-~~DISQUS~~