User Tools

Site Tools


ess:design-installation-manual

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
ess:design-installation-manual [2020-07-29 13:42]
guy_stewart
ess:design-installation-manual [2020-07-29 15:37] (current)
marmour [7.2 Three-phase ESS]
Line 693: Line 693:
  
 (Make sure you install the ESS on L1. If it's installed on another phase the visualisation will be wrong.) (Make sure you install the ESS on L1. If it's installed on another phase the visualisation will be wrong.)
-==== 7.Three-phase ESS ====+==== 7.Three-phase ESS ====
  
 A three-phase ESS system has at least one Multi installed on each phase. We recommend leaving the phase-compensation setting to its default: enabled. A three-phase ESS system has at least one Multi installed on each phase. We recommend leaving the phase-compensation setting to its default: enabled.
Line 953: Line 953:
   - Now check MPPT Charge Voltage Setpoint. It is supposed to be above actual battery voltage.   - Now check MPPT Charge Voltage Setpoint. It is supposed to be above actual battery voltage.
  
-Note that those last two set points are determined by software; and calculated based on the setpoints sent by the (CANbus connected) lithium battery: you can'change change them manually. Looking at them however does help understanding why certain things are happening;+Note that those last two set points are determined by software; and calculated based on the setpoints sent by the (CANbus connected) lithium battery: you can't change them manually. Looking at them however does help understanding why certain things are happening;
 ===== DISQUS ===== ===== DISQUS =====
 ~~DISQUS~~ ~~DISQUS~~
ess/design-installation-manual.txt · Last modified: 2020-07-29 15:37 by marmour