Differences

This shows you the differences between two versions of the page.

--- ess:design-installation-manual [2020-07-29 15:37] – [7.2 Three-phase ESS] marmour
+++ ess:design-installation-manual [2020-08-09 21:53] – [6. Controlling depth of discharge] jono
@@ Line 347: / Line 347: @@
   * Victron 12.8V Lithium batteries, and other lithium batteries that have passive cell balancing
-Because it makes no sense to leave a battery discharged, without reserve power in case of mains failure, we recommend leaving BatteryLife enabled on the following battery technologies, too:
+Because it makes no sense to leave a battery discharged, without reserve power in case of mains failure, we recommend leaving BatteryLife enabled for systems using Lithium with active cell balancing, however it //can// be disabled in this case.
-  * Lithium with active cell balancing
+Redflow specifies that BatteryLife should be disabled in [[battery_compatibility:redflow_zcell|Redflow ZCell]] installations, because the ZCell battery can rest at zero SoC without damage for an unlimited period, and also because the BatteryLife function conflicts with the ZCell battery maintenance cycle.
-  * [[battery_compatibility:redflow_zcell|Redflow ZCell]]
-However, BatteryLife //can// be disabled in these cases.
 === 4.3.2 Grid meter installed ===
@@ Line 540: / Line 537: @@
 Start the generator and check that the system begins to charge the batteries.
 ===== 6. Controlling depth of discharge =====
-//(Note: All absolute voltages mentioned in the example below refer to a 12V system. Voltages should be multiplied by x2 or x4 for a 24V or 48V system, respectively.)//
+//(Note: All absolute voltages mentioned in the example below refer to a 12V system. Voltages should be multiplied by x2 for a 24V system or x4 for a 48V system.)//
 ==== 6.1 Overview ===