ess:design-installation-manual
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
ess:design-installation-manual [2020-07-29 13:42] – guy_stewart | ess:design-installation-manual [2020-07-29 15:37] – [7.2 Three-phase ESS] marmour | ||
---|---|---|---|
Line 693: | Line 693: | ||
(Make sure you install the ESS on L1. If it's installed on another phase the visualisation will be wrong.) | (Make sure you install the ESS on L1. If it's installed on another phase the visualisation will be wrong.) | ||
- | ==== 7.2 Three-phase ESS ==== | + | ==== 7.3 Three-phase ESS ==== |
A three-phase ESS system has at least one Multi installed on each phase. We recommend leaving the phase-compensation setting to its default: enabled. | A three-phase ESS system has at least one Multi installed on each phase. We recommend leaving the phase-compensation setting to its default: enabled. | ||
Line 953: | Line 953: | ||
- Now check MPPT Charge Voltage Setpoint. It is supposed to be above actual battery voltage. | - Now check MPPT Charge Voltage Setpoint. It is supposed to be above actual battery voltage. | ||
- | Note that those last two set points are determined by software; and calculated based on the setpoints sent by the (CANbus connected) lithium battery: you can' | + | Note that those last two set points are determined by software; and calculated based on the setpoints sent by the (CANbus connected) lithium battery: you can't change them manually. Looking at them however does help understanding why certain things are happening; |
===== DISQUS ===== | ===== DISQUS ===== | ||
~~DISQUS~~ | ~~DISQUS~~ |
ess/design-installation-manual.txt · Last modified: 2021-01-14 08:35 by marmour