Differences

This shows you the differences between two versions of the page.

--- ess:design-installation-manual [2020-07-20 16:50] – mvader
+++ ess:design-installation-manual [2020-07-29 13:42] – guy_stewart
@@ Line 894: / Line 894: @@
 Switching off in overload, while connected to the grid, is caused by the active Loss of Mains (LOM) detection, linked to the country code as configured in VEConfigure3.
-This behaviour occurs when the AC supplied on the AC-in of the Multi or Quattro is 'weak'. By 'weak' we mean that the AC connection to the utility has a higher impedance than usual. For example a generator, or an old or remote house connected with a too-long and/or too/thin cable to the utility.
+This behaviour occurs when the AC supplied on the AC-in of the Multi or Quattro is 'weak'. By 'weak' we mean that the AC connection to the utility has a higher impedance than usual. For example a generator, or a house connected with a too-long and/or too-thin cable from the Inverter/Charger to the utility.
 For the solution and configuration options, see [[ve.bus:grid-codes-and-loss-of-mains-detection|]].