Differences

This shows you the differences between two versions of the page.

--- dc_distribution [2020-01-02 16:03] – [Installation] marmour
+++ dc_distribution [2021-02-15 15:23] – [Installation] mvader
@@ Line 22: / Line 22: @@
 The Power In contains a negative and positive DC bus-bar with M8 bolts in which to connect batteries cables. It can take cables up to 22 mm in diameter through the bottom entry guides, and no limit via the two side connections.
 ===== Lynx shunt =====
 {{:drafts:lynx_shunt.png?200|}}{{https://www.victronenergy.com/upload/products/cat-100122Lynx%20Shunt%20VE.Can%20VE.NET%20inside.png?200}}
@@ Line 54: / Line 55: @@
 A - There is a program available to change this but as the default is 0, which is the same as what a CCGX reads we would not advise changing this!!
+Further[[https://community.victronenergy.com/topics/lynx%20shunt.html| Questions and Answers about the Lynx Shunt are available on the Victron Community topic.]]
 ===== Lynx Distributor =====
@@ Line 68: / Line 70: @@
 When all is OK, only the central LED is green; when a fuse has blown (or is missing) the central and blow fuse circuit LEDs turn red. If you are not using all connection points in your DC distribution, it may be necessary to fit dummy fuses to extinguish the red LEDs.
-A future upgrade is planned to also send info back to the GX device over the VE-can, but is not yet implemented.
 ==== Fuses ====
 Uses MEGA fuses. Please note that some MEGA fuses are only rated to 36Volt (suitable for 24V systems), You must use 58/64V rated fuses for 48V systems.
@@ Line 91: / Line 90: @@
 A - That’s for manual settings, please don’t touch as the system will auto configure (up to 32 battery’s )
-Q - The Distributor has a 6-pin header block. What is it for?
-A - In the future, the read out of fuses, but this is not supported yet.