Differences

This shows you the differences between two versions of the page.

--- battery_compatibility:pylontech_phantom [2026-10-11 21:52] – guy_stewart
+++ battery_compatibility:pylontech_phantom [2026-10-12 04:01] (current) – guy_stewart
@@ Line 60: / Line 60: @@
 __MPPTs with a VE.Direct port__
-MPPTs are controlled via the [[venus-os:start|GX device]]. Make sure the [[venus-os:start|GX device]] runs v2.15 or later, and the MPPTs to 1.37 or the latest available version.
+MPPTs are controlled via the [[venus-os:start|GX device]]. Make sure the [[venus-os:start|GX device]] runs at least the minimum version in section 1.2, and the MPPTs to 1.37 or the latest available version.
 The MPPT requires connection to the [[venus-os:start|GX device]] to regulate charge currents as the batteries require (due to temperature, etc)
@@ Line 302: / Line 302: @@
 ===== 7. Example Wiring Diagram =====
-{{:battery_compatibility:ds_-_pylontech_-_managed_lithium_battery_-_2021-3-11.jpg?direct&800|}}
+{{:battery_compatibility:ds_-_pylontech_-_managed_lithium_battery_-
+_2021-3-11.jpg?direct&800|}}
 ===== 8. Troubleshooting =====
@@ Line 328: / Line 329: @@
 If its not visible, check:
-  * [[venus-os:start|GX device]] firmware version (update to latest version, v2.15 or later)
+  * [[venus-os:start|GX device]] firmware version (update to the latest version; section 1.2 gives the minimum)
   * CAN-bus communication cabling between Pylontech and Victron system. Make sure that it is in the right way around.
   * Pylontech system is up and running (LEDs are on)
@@ Line 338: / Line 339: @@
 === Step 3. Check the Pylontech manual ===
-The Pylontech manual contains additional diagnostic and troubleshooting information, specifically around decoding any indicator LEDs.
+The Pylontech manual contains additional diagnostic and troubleshooting information, specifically around
+decoding any indicator LEDs.
 ===== 9. FAQ and Known Issues=====