3. Limitations
3.1. VictronConnect vs VEConfigure & VEFlash
VictronConnect is replacing VEConfigure and VEFlash. Its easier to use and works on more devices, not only on Windows.
The following features are not yet supported in VictronConnect. If you require this advanced functionality, you will still need to use VEConfigure.
Assistants (eg AC PV, ESS)
Virtual Switch, though some of the most commonly used Virtual Switch functionality is available via the new AC input control feature.
Lithium Battery Wizard (for lithium battery types that require installation of an Assistant eg VE.Bus BMS)
External Current Sensor - This is for use with the Multiplus-II external current sensor
3.2. Required firmware versions
For full functionality (data readout, changing settings, updating firmware), firmware version 415 or higher is required, which is only available for VE.Bus products with a new microcontroller - recognisable by the 7-digit software number on a sticker on the unit, the first two digits must start with 26 or 27.
For VE.Bus products with the old microcontroller (first two digits start with 19 or 20 only), the minimum supported firmware version is 19xx200 for European units and 20xx200 for 120V models and is limited to data readout. Changes to the settings or firmware updates are not possible.
Even older VE.Bus products such as 18xxxxx are not supported.
For more information, see the VE.Bus firmware versions explained document. When above requirements are not met, use VEFlash for firmware updating.
3.3. VE.Bus Smart dongle limitations
When connected over bluetooth, using the VE.Bus Smart Dongle, only status data, voltages, and other information can be read. And it can be operated: switch between On, Off and Charger-only mode, and set a Shore current input limit. No changes can be made to the product.
An MK3-USB is required to change settings and perform firmware updates and settings. And, as that requires a USB port, it is not possible to change inverter/charger configuration or perform firmware updates on a Apple iPad or iPhone.
VictronConnect does not work with the MK2-USB.