Differences

This shows you the differences between two versions of the page.

--- vrm_portal:dashboard [2022-03-14 10:52] – guystewart
+++ vrm_portal:dashboard [2022-07-03 12:47] – [3.1 Inverter controls in VRM] guystewart
@@ Line 116: / Line 116: @@
 ===== 3. Control your devices in VRM =====
-VRM offers control over some of your Victron devices, straight from the VRM dashboard. With this feature, you can quickly adjust the settings of your inverter, ESS or relay switches, without needing to open the remote console.
+VRM offers control over some of your Victron devices, straight from the VRM dashboard. With this feature, you can quickly adjust the settings ESS or relay switches, without needing to open the remote console.
 To access it, head to your VRM dashboard.
@@ Line 126: / Line 126: @@
 {{:vrm_portal:vrm-controls-1.jpg?800|}}
-{{:vrm_portal:vrm-controls-2.jpg?800|}}
+{{:vrm_portal:vrm-controls-2-revised.jpg?800|}}
 ==== 3.1 Inverter controls in VRM ====
-The AC input current limit of the grid can be adjusted. For this, you can either select one of the pre-defined values, or enter your own input limit preference in amps.
+Inverter controls can be made available on the VRM Dashboard, but require an additional step to enable in the Settings for that specific VRM Installation. This is to prevent accidentally switching off the system.
+{{:vrm_portal:victron_enable_inverter_control.jpg?800|}}
+It is ONLY recommended to enable this easy system shutdown control for small systems in non-critical environments. It is STRONGLY recommended to leave this feature disabled for large mission critical systems, or where there are multiple users with access to the Admin controls.
+Once enabled, you can access the settings via the control button.
-Changing the inverter mode is also possible in VRM. You can switch between charger or inverter only, turning it on or off.
+{{:vrm_portal:inverter_control_step_1.jpg?800|}}
-After selecting a change to the inverter mode, you will get 5 seconds to cancel the request. After this, the change is sent to the device.
-{{:vrm_portal:vrm-controls-3.jpg?400|}}
+{{:vrm_portal:inverter_control_step_2.jpg?800|}}
+Note - there is a limitation where these controls are not available when using a Digital Multi Control, or VE.Bus BMS in the system.
 ==== 3.2 ESS controls in VRM ====