victronconnect:ve-smart-networking
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
victronconnect:ve-smart-networking [2019-10-10 13:58] – [3.1 VE.Smart Networking products compatibility] mvader | victronconnect:ve-smart-networking [2019-12-13 11:41] – tabreu | ||
---|---|---|---|
Line 5: | Line 5: | ||
A VE.Smart Network is a wireless network which allows a number of Victron products to exchange information. It is a wireless technology using Bluetooth Smart. | A VE.Smart Network is a wireless network which allows a number of Victron products to exchange information. It is a wireless technology using Bluetooth Smart. | ||
- | Use VE.Smart to add remote voltage- and temperature- sensing to your Victron MPPT Solar Chargers. Connect either a BMV battery monitor - or the new [[https:// | + | Use VE.Smart to add remote voltage, temperature |
- | + | ||
\\ | \\ | ||
{{youtube> | {{youtube> | ||
- | ===== 2. Voltage | + | |
+ | You can also now use the VE.Smart Networking to synchronise the charger algorithms from your Solar Chargers and improve even further your charge-efficiency and battery life. This feature is only available on SmartSolars with firmware version equal or higher then v1.47 (Ve.Direct SmartSolars) and v1.04 (Ve.Can SmartSolars). | ||
+ | |||
+ | ===== 2. Voltage, temperature | ||
The battery voltage data is used to compensate for voltage-drop over the battery cables. This ensures that the battery is charged with the exact voltage as configured in the charger - instead of a lower voltage due to resistance in the wiring. | The battery voltage data is used to compensate for voltage-drop over the battery cables. This ensures that the battery is charged with the exact voltage as configured in the charger - instead of a lower voltage due to resistance in the wiring. | ||
Line 17: | Line 18: | ||
For lithium batteries the charge-voltages remain the same at all temperatures, | For lithium batteries the charge-voltages remain the same at all temperatures, | ||
+ | |||
+ | The battery current is used to allow the tail current setting (see the [[victronconnect: | ||
+ | |||
===== 3. Specifications ===== | ===== 3. Specifications ===== | ||
Line 22: | Line 26: | ||
^Product range ^ Compatible ^ Function ^ | ^Product range ^ Compatible ^ Function ^ | ||
- | |BMV-700 | + | |BMV-700 |
- | |BMV-702 | + | |BMV-702 |
- | |BMV-712 | + | |BMV-712 |
- | |SmartSolar MPPTs | Yes <sup> (2)</ | + | |SmartSolar MPPTs | Yes <sup> (2)</ |
|BlueSolar MPPTs | Yes | Uses received sense data to optimize charging | | |BlueSolar MPPTs | Yes | Uses received sense data to optimize charging | | ||
|Phoenix Smart IP43 Charger | |Phoenix Smart IP43 Charger | ||
Line 33: | Line 37: | ||
- To measure battery temperature, | - To measure battery temperature, | ||
- Check the table below to see which models are incompatible with this feature. | - Check the table below to see which models are incompatible with this feature. | ||
+ | - Synchronised charging is available on the SmartSolar on version v1.47 or higher except for the models listed on the table below | ||
victronconnect/ve-smart-networking.txt · Last modified: 2021-01-14 14:23 by marmour