Differences

This shows you the differences between two versions of the page.

--- venus-os:v2.60 [2020-06-29 22:21] – [B) Changes to the NMEA2000-out chapter] mvader
+++ venus-os:v2.60 [2020-12-15 16:49] (current) – mvader
@@ Line 17: / Line 17: @@
   - (optional - only when using ModbusTCP protocol): only enable ModbusTCP on one of the GX Devices
   - Only connect the main GX Device to VRM; it will also transmit tank levels received from the secondary units.
-  - And so forth.
+  - We recommend to connect all VE.Bus and VE.Direct products to the main GX Device. Connecting the via a secondary device will work, but has limitations. For example that Remote configuration doesn’t work, DVCC control will not work, and neither will remote firmware updates. Expanding the VE.Direct ports through USB does give full functionality, which is therefor the recommended method. More information about thus in chapter 1.4.?.
 ==== Steps to configure ====
@@ Line 47: / Line 47: @@
 tbd. Include the new min /max, as well as ten point calibration and so forth. Include screenshots.
+===== D) Reset button seems to have gone missing in Cerbo manual ====
+(make sure to also check Venus GX new manual!!)
+https://www.victronenergy.com/live/venus-gx:start?rev=1589486700#small_button_located_to_the_right_of_the_green_14-terminal_connector_block
+===== E) Add frequencies to the manual, (required by some countries) =====
+<code>
+Operating Frequencies:
+Frequency Range                                             Power Output
+.402-2.48 GHz                 Bluetooth            4.9 mW
+.402-2.48 GHz                 Bluetooth            5.2 mW
+.412-2.462 GHz               2.4 GHz WiFi       88.1 mW
+</code>