Differences

This shows you the differences between two versions of the page.

--- venus-os:extended [2020-05-16 16:12] – [5.5 Signal K FAQ] mvader
+++ venus-os:extended [2020-05-17 10:26] – [3. How to install] mvader
@@ Line 57: / Line 57: @@
   * **Step 2.** Disable Auto updates. See Settings -> Firmware -> Online updates in Remote Console.
   * **Step 3.** Download the latest Venus-OS Extended image from the last comments on [[https://github.com/victronenergy/venus/issues/378|this issue]].
+  * **Step 4.** Install that file using the [[ccgx:firmware_updating|GX Offline install method]]. Requires a USB-stick or Micro SD-Card.
+  * **Step 5.** Verify that the image was successfully installed: go to Settings -> Services, and check that Signal K and Node-RED are now available to enable.
+  * **Step 6.** Enable either Signal K or Node-RED. Note that though its possible to enable both, doing so on a Venus GX is "pushing it", the system might become slow. Installer access level is required to enable/disable these servers, see Settings -> General.
+  * **Finished**. The Venus OS Extended image has now been installed successfully. Continue in either the Node-RED or the Signal K chapter below.
 === Special note for the RaspberryPi ===