vedirect_lorawan
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
| vedirect_lorawan [2020-05-28 08:31] – mvader | vedirect_lorawan [2020-07-14 17:42] – [What's in the box?] bob | ||
|---|---|---|---|
| Line 76: | Line 76: | ||
| - Mount the LoRaWAN Module close to the device you wish to monitor | - Mount the LoRaWAN Module close to the device you wish to monitor | ||
| - Connect the VE.Direct cable between devices | - Connect the VE.Direct cable between devices | ||
| - | - Connect the DC Power (8V - 68V) | + | - Connect the DC Power (8V - 68V, looking to the module with green connector below of the module, the positive is on the left) |
| - After a short wait the LED will blink green indicating that all is OK | - After a short wait the LED will blink green indicating that all is OK | ||
| - Go to the VRM Portal to add your installation | - Go to the VRM Portal to add your installation | ||
vedirect_lorawan.txt · Last modified: 2023-10-10 11:54 by sloges