Differences

This shows you the differences between two versions of the page.

--- vedirect_lorawan [2020-05-28 07:16] – [Introduction] guy_stewart
+++ vedirect_lorawan [2020-07-14 17:42] – [What's in the box?] bob
@@ Line 1: / Line 1: @@
-**tip: Software Update**
+====== VE.Direct LoRaWAN module manual ======
+**NOTICE: Software Update**
 All units with versions earlier than v1.05 have been recalled for a free software update; due to the issue that they stop transmitting after a while. How long it takes before they stop transmitting varies; and is typically between 12 and 60 days.
 You can find your version number in the VRM portal. Go to your installation -> open device list in the left menu -> unfold the gateway tab and find the firmware version.
-====== VE.Direct LoRaWAN module manual ======
 ===== Introduction =====
@@ Line 74: / Line 76: @@
   - Mount the LoRaWAN Module close to the device you wish to monitor
   - Connect the VE.Direct cable between devices
-  - Connect the DC Power (8V - 68V)
+  - Connect the DC Power (8V - 68V, looking to the module with green connector below of the module, the positive is on the left)
   - After a short wait the LED will blink green indicating that all is OK
   - Go to the VRM Portal to add your installation