Differences

This shows you the differences between two versions of the page.

--- vebus_smart_dongle_manual [2019-06-21 16:13] – [VE.Bus Smart Dongle - manual] mvader
+++ vebus_smart_dongle_manual [2019-06-24 14:54] – Moved system requirements to the top of the manual jpasop
@@ Line 2: / Line 2: @@
 {{:benh7ta_79897301-690x277.png?400|}}
+===== System requirements =====
+**Multi firmware versions before 415 are not supported**
+^ Function                                            ^ Minimum Multi firmware version ^ Note ^
+| Battery voltage and temperature sense               | 419                            |      |
+| Input current limit and on/off/charger only control | 415                            | Not supported when a DMC and/or VeBus BMS is installed |
 ===== Introduction =====
@@ Line 50: / Line 58: @@
   - Plug the connector block into the dongle.
   - Connect the dongle to the Multi's Ve.Bus interface, using a standard RJ45 UTP cable
-===== System requirements =====
-**Multi firmware versions before 415 are not supported**
-^ Function                                            ^ Minimum Multi firmware version ^ Note ^
-| Battery voltage and temperature sense               | 419                            |      |
-| Input current limit and on/off/charger only control | 415                            | Not supported when a DMC and/or VeBus BMS is installed |
 ===== LED Status codes =====