ve.bus:manual_parallel_and_three_phase_systems
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
ve.bus:manual_parallel_and_three_phase_systems [2019-11-28 12:53] – mvader | ve.bus:manual_parallel_and_three_phase_systems [2019-12-09 13:10] – [Configuration] mvader | ||
---|---|---|---|
Line 97: | Line 97: | ||
The following settings need to be made in the master of each phase: | The following settings need to be made in the master of each phase: | ||
* Inverter output voltage | * Inverter output voltage | ||
- | * Input current limits.\\ This makes it possible to set a different | + | * Input current limits\\ |
* UPS function on/off | * UPS function on/off | ||
* PowerAssist settings | * PowerAssist settings | ||
Line 112: | Line 112: | ||
==== Assistants ==== | ==== Assistants ==== | ||
- | | + | |
+ | Assistants can be used to expand the potential configuration options of your system, and are required in some installation types. When using assistants with multiple units, some assistants are required to be loaded onto all units in the system individually, | ||
+ | |||
+ | | ||
* PV Inverter Assistant needs to be loaded into each unit in the system. | * PV Inverter Assistant needs to be loaded into each unit in the system. | ||
* The VE.Bus BMS and the Two-Signal BMS support Assistant also need to be loaded in each unit in the system. | * The VE.Bus BMS and the Two-Signal BMS support Assistant also need to be loaded in each unit in the system. | ||
Line 120: | Line 123: | ||
Tip: a quick way to load Assistants into each unit in the system is to save the settings after configuring the master in L1. Then open VEConfigure for another unit and load that file. VEConfigure will automatically adapt the Assistants for the slaves. (note: In some cases you might get some warnings. Please step through the assistant in that case.) | Tip: a quick way to load Assistants into each unit in the system is to save the settings after configuring the master in L1. Then open VEConfigure for another unit and load that file. VEConfigure will automatically adapt the Assistants for the slaves. (note: In some cases you might get some warnings. Please step through the assistant in that case.) | ||
- | |||
===== Tips and hints ===== | ===== Tips and hints ===== | ||
* {{: | * {{: |
ve.bus/manual_parallel_and_three_phase_systems.txt · Last modified: 2024-02-09 13:07 by jpasop