system_integration:hub4_grid_parallel-ccgx_control_loop
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
system_integration:hub4_grid_parallel-ccgx_control_loop [2015-10-27 14:22] – [Hub-4 / grid parallel - manual] mvader | system_integration:hub4_grid_parallel-ccgx_control_loop [2015-10-29 16:30] – [8. Using the Wired HUB-4 AC Sensor to measure PV Inverter output] edevries | ||
---|---|---|---|
Line 190: | Line 190: | ||
Instead of used for the Hub-4 regulation, the same three phase meter can be configured to measure output of a PV Inverter. Make sure the check Paragraph 1.3 in the [[ccgx: | Instead of used for the Hub-4 regulation, the same three phase meter can be configured to measure output of a PV Inverter. Make sure the check Paragraph 1.3 in the [[ccgx: | ||
- | Installation is similar to the AC sensor on the grid. Terminals 1, 4 and 7 should face the PV inverter. On the CCGX change the //Role// of the meter to //PV inverter//. You can now also chose its // | + | Installation is similar to the AC sensor on the grid. Terminals 1, 4 and 7 should face the PV inverter. On the CCGX change the //Role// of the meter to //PV inverter//. You can now also chose its // |
There are 3 options to connect the extra AC sensor: | There are 3 options to connect the extra AC sensor: |
system_integration/hub4_grid_parallel-ccgx_control_loop.txt · Last modified: 2019-01-22 10:41 by 127.0.0.1