mppt-error-codes
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
mppt-error-codes [2019-07-12 16:44] – [Err 68 - Network misconfigured] mvader | mppt-error-codes [2019-11-30 10:10] – [Err 119 - Settings data lost] boekel | ||
---|---|---|---|
Line 68: | Line 68: | ||
Disconnect all wires, and then reconnect all wires. If the error persists the charge controller is probably faulty. | Disconnect all wires, and then reconnect all wires. If the error persists the charge controller is probably faulty. | ||
+ | |||
+ | Note that this error was introduced in v1.36. So when doing an update, it might look like the firmware update caused this issue; but it doesn' | ||
==== Err 33 - PV over-voltage ==== | ==== Err 33 - PV over-voltage ==== | ||
Line 146: | Line 148: | ||
This error will not auto-reset. To get it working again: | This error will not auto-reset. To get it working again: | ||
- | - First, restore it to factory defaults. | + | - First, restore it to factory defaults. |
- Disconnect the charge controller from all power-sources | - Disconnect the charge controller from all power-sources | ||
- wait 3 minutes, and power up again. | - wait 3 minutes, and power up again. |
mppt-error-codes.txt · Last modified: 2024-02-12 05:48 by guy_stewart