https://www.victronenergy.com/live/ 2026-05-13T19:15:23+00:00 https://www.victronenergy.com/live/ https://www.victronenergy.com/live/_media/wiki:logo.png text/html 2025-02-06T21:04:58+00:00 Anonymous (anonymous@undisclosed.example.com) https://www.victronenergy.com/live/ve.can:changing_nmea2000_instances?rev=1738875898&do=diff Changing NMEA2000 instances 1. Introduction 1.1 Purpose of NMEA 2000 instances Instances are used in an NMEA 2000 network to identify multiple similar products connected on the same network. As an example, take a system with two battery monitors (one for the main battery bank, and another for the hydraulic-thruster bank) and also a Quattro inverter/charger. All three of those devices will send their battery voltage measurements out on the N2K network. For the displays to show these values a… text/html 2019-01-22T09:43:06+00:00 Anonymous (anonymous@undisclosed.example.com) https://www.victronenergy.com/live/ve.can:pgn_details?rev=1548150186&do=diff NMEA2000 Switch bank PGN definitions This document is an add-on to our Datacommunication whitepaper. That whitepaper contains a list of PGNs transmitted by each product type. This document defines the bit definitions of the switch banks. Download the main document, the Datacommunication whitepaper, from the text/html 2020-04-02T22:30:51+00:00 Anonymous (anonymous@undisclosed.example.com) https://www.victronenergy.com/live/ve.can:start?rev=1585866651&do=diff NMEA2000 and VE.Can * Marine Integration Guide * Changing NMEA2000 instances * NMEA2000 Switch bank PGN definitions text/html 2019-08-15T10:52:00+00:00 Anonymous (anonymous@undisclosed.example.com) https://www.victronenergy.com/live/ve.can:updating_firmware?rev=1565866320&do=diff How to update firmware - VE.Can This page explains the procedure to update firmware for products that have a VE.Can port. There are two ways: * Remotely via internet - applies to systems that have a GX device, and are internet-connected.it can be done remotely. text/html 2020-01-06T22:05:01+00:00 Anonymous (anonymous@undisclosed.example.com) https://www.victronenergy.com/live/ve.can:ve.bus_to_ve.can_interface_manual?rev=1578348301&do=diff VE.Bus to VE.Can interface manual Note that for brevity, Multis and Quattros are called VE.Bus devices in this manual. This product is deprecated, and no longer required! This interface was, only!, used in Hub-1 systems with grid-feedback enabled text/html 2022-01-27T08:34:14+00:00 Anonymous (anonymous@undisclosed.example.com) https://www.victronenergy.com/live/ve.can:ve.can_resistive_tank_sender_adapter?rev=1643272454&do=diff VE.Can Resistive Tank Sender Adapter manual 1. Introduction The VE.Can resistive tank sender adapter allows a standard resistive tank level sender to connect to the Color Control GX. * High ±1% Accuracy * Suits European standard 0-180 and US standard 240-30 Ohm Senders