ess:ess_mode_2_and_3
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
ess:ess_mode_2_and_3 [2018-08-03 16:21] – [6. Further examples for external control] iburger | ess:ess_mode_2_and_3 [2018-10-26 23:29] – [3.6 Using the MK3 directly instead of CCGX] guy_stewart | ||
---|---|---|---|
Line 156: | Line 156: | ||
* If your system contains a ESS compatible AC-Sensor which is set up as grid meter, the CCGX will automatically enter mode 1 and start updating the AC power setpoint continuously. You can disable this behavior by setting // | * If your system contains a ESS compatible AC-Sensor which is set up as grid meter, the CCGX will automatically enter mode 1 and start updating the AC power setpoint continuously. You can disable this behavior by setting // | ||
- | ==== 3.6 Using the MK3 directly instead of CCGX ==== | + | ==== 3.6 Using the MK3 directly instead of via CCGX ==== |
=== 3.6.1 Introduction === | === 3.6.1 Introduction === | ||
- | In this setup, it is not necessary to use a CCGX. Instead an MK3 is used. We have both MK2-RS232 and an MK3-USB available, see the pricelist. | + | In this setup, it is not necessary to use a CCGX for the control interface. Instead an MK3 is used. We have both MK2-RS232 and an MK3-USB available, see the pricelist. |
The MK3-USB has replaced the MK2-USB. There are no differences in the protocol. | The MK3-USB has replaced the MK2-USB. There are no differences in the protocol. |
ess/ess_mode_2_and_3.txt · Last modified: 2023-02-14 15:25 by mvader