Differences

This shows you the differences between two versions of the page.

--- ess:design-installation-manual [2019-03-08 14:50] – mvader
+++ ess:design-installation-manual [2019-04-03 13:27] – guy_stewart
@@ Line 410: / Line 410: @@
 This sets the point at which power is taken from the grid when the installation is in self-consumption mode. Setting this value slightly above 0W prevents the system from feeding back power to the grid when there is a bit of over-shoot in the regulation. The default value is therefore 50W - but should be set to a higher value on large systems.
 ==== 4.4 Venus-device - Scheduled Charging ====
@@ Line 604: / Line 605: @@
 (This 0.1 V is the threshold for 12 V systems; for 24 V the threshold is 0.2 V above; and for 48 V it is 0.4V above.)
+==== 6.5 ESS Battery Status Code Numbers ====
+In addition to the charger states (Bulk/Absorption/Float), there are additional Discharging and Sustain codes that provide at-a-glance information on the Pages Overview of GX display.
+{{:ess:victron_-_ess_codes.jpg?direct}}
+The key for these codes is:
+  * #1: SOC is low
+  * #2: BatteryLife is active
+  * #3: BMS disabled charging
+  * #4: BMS disabled discharge
+  * #5: Slow Charge in progress (part of BatteryLife, see above)
+  * #6: User configured a charge limit of zero.
+  * #7: User configured a discharge limit of zero.
 ===== 7. Phase compensation - further information =====
@@ Line 879: / Line 898: @@
 ===== DISQUS =====
 ~~DISQUS~~