Differences

This shows you the differences between two versions of the page.

--- ccgx:ccgx_faq [2019-05-17 16:18] – [Q1: I cannot switch my Multi/Quattro system on or off] john_r
+++ ccgx:ccgx_faq [2019-06-06 15:54] – [Q24: What is Error #42?] mvader
@@ Line 183: / Line 183: @@
 Please check the remote switch connection on the Multi control PCB. There should be a wire bridge between the left and middle terminal. The CCGX switches a line which enables the power of the Multi control board. After 10 seconds this line is released and the Multi should take over from there. When the remote switch connection is not wired the Multi is unable to take over it's own supply. The CCGX will retry, the Multi will boot and after 10 seconds stop, and so on.
+==== Q24: What is Error #42? ====
+If the GX Device shows an Error 42 - Hardware fault. In that case, the flash storage on the device is corrupt. As a result, settings will not be saved (rebooting resets back to default) and other problems will rise.
+This error is not recoverable in the field or by repair departments. Contact your dealer for a replacement.
+Firmware versions until v2.30 did not report the error. Since v2.30; its visible on the device itself (in the GUI) and on the VRM Portal.
 ===== GPL Note =====