Differences

This shows you the differences between two versions of the page.

--- battery_compatibility:hubble [2023-11-01 08:57] – [Parallel Limitations] warwickchapman
+++ battery_compatibility:hubble [2024-03-10 16:51] (current) – [Ve.Configure 3] warwickchapman
@@ Line 100: / Line 100: @@
     - CAN Mode => Victron
     - CAN Conn. To => Inverter
-    - Serial Conn. To => Battery
+    - Serial Conn. To => Battery (External CloudLink only)
-  - Site Settings => Inverter Brand => Victron
+    - RS232 Conn. To => Nothing (+ models with internal CloudLink only)
+    - Adaptive Cell Limits => Enable
+    - Save & Confirm
+  - Site Settings =>
+    - Inverter Brand => Victron
+    - (Optional) Add the IP address of the GX device - improves CloudLink display
+    - Save & Confirm
+    - Wait for Confirmation, scroll down and click Reboot for the settings to take effect
 Connect the Battery side of the type A cable into the CloudLink CAN port. Connect the Victron side of the type A cable to the CAN BMS port on the GX device (configured for 500kbps CAN BMS). The Hubble battery will display in the device list of the GX device.
@@ Line 165: / Line 172: @@
     - Battery capacity: Use 100Ah per Hubble battery (excl. AM-10: 200Ah, AM-3: 50Ah, S-200: 200Ah, Blade: 137Ah). Eg. If there are 3 x AM-4, then capacity is 300Ah.
     - Sustain voltage, set the value from the tables below
-    - Dynamic cutoff, set the fallback value from the tables below
+    - Dynamic cutoff, use the low cutoff value from the tables below
     - Restart offset, set the value from the tables below