Differences

This shows you the differences between two versions of the page.

--- battery_compatibility:bmz_ess [2019-08-15 12:13] – replace venus-device with GX device guy_stewart
+++ battery_compatibility:bmz_ess [2020-01-31 07:29] – alexander.joist_ibc-solar.co.za
@@ Line 1: / Line 1: @@
-====== Victron & BMZ ESS 3.0 / ESS 7.0 =====
+====== Victron & BMZ ESS 7.0 / ESS 9.0 / ESS X=====
-The combination of Victron products with the BMZ ESS 7.0 battery has been tested and certified by the R&D departments. The combination is actively supported by both companies.
+The combination of Victron products with the BMZ ESS battery has been tested and certified by the R&D departments. The combination is actively supported by both companies.
 ==== 1. Introduction ====
@@ Line 37: / Line 37: @@
   - Check "Enable battery monitor"
   - Enter the battery capacity:
-    - BMZ ESS 3.0 - 121.5 Ah
+    - BMZ ESS 7.0 - 121.5 Ah
-    - BMZ ESS 7.0 - 156.6 Ah
+    - BMZ ESS 9.0 - 156.6 Ah
     - BMZ ESS X - 186.3 Ah
   - The other parameters ("State of charge when bulk finished" and "Charge efficiency") can be left to their default setting. They are not used in this setup.
@@ Line 70: / Line 70: @@
   * The parameters option within the battery page shows the actual battery charge and discharge limits:{{ :battery_compatibility:batteryparameters.png?nolink&290 | }}
+==== 6. DVCC Settings ====
+Enabling DVCC changes a GX device from a passive monitor into an active controller. The available features and effects of enabling DVCC depend on the type of battery used. The effect also depends on the installed Victron components and their configuration.
+This table shows the recommend settings for different battery types:
+{{ :ccgx:dvcc_table2.png?nolink&800 |}}
 ===== DISQUS =====
 ~~DISQUS~~