assistants:hub1_and_hub2_notes
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionLast revisionBoth sides next revision | ||
drafts:hub_notes [2015-12-15 16:30] – johannes | assistants:hub1_and_hub2_notes [2019-01-21 10:36] – [DISQUS Comments] ictbeheer | ||
---|---|---|---|
Line 1: | Line 1: | ||
- | ====== Hub Assistant notes ====== | + | ====== Hub-1 and Hub-2 Assistant notes ====== |
===== 1. Special states ===== | ===== 1. Special states ===== | ||
Line 75: | Line 75: | ||
- when a Lynx BMS signals 'High voltage/ | - when a Lynx BMS signals 'High voltage/ | ||
- | ===== 3. FAQ ===== | + | ===== 4. FAQ ===== |
=== Why does my Hub-2 system start charging the first day after setting it up? === | === Why does my Hub-2 system start charging the first day after setting it up? === | ||
Line 107: | Line 107: | ||
Mostly when having a charge current higher then 10-15% the rate of charging, the calculated SOC does not match reality. Then the Absorbtion voltage is reached too soon, setting the SOC directly on a certain level (set in the battery monitor page in ve configure) | Mostly when having a charge current higher then 10-15% the rate of charging, the calculated SOC does not match reality. Then the Absorbtion voltage is reached too soon, setting the SOC directly on a certain level (set in the battery monitor page in ve configure) | ||
Same at discharging, | Same at discharging, | ||
+ | |||
+ | === Why does AES not work when using Hub-1 policy 3? === | ||
+ | Hub1 policy3 is ' | ||
+ | |||
+ | With this policy the unit will be in Inverter mode when possible but will stay synchronized to the mains. So it will be able to switch quickly when the Load connect condition becomes active. Therefor AES does not work. | ||
- | [ elaborate ] | ||
- | ===== DISQUS Comments ===== | ||
- | ~~DISQUS~~ |
assistants/hub1_and_hub2_notes.txt · Last modified: 2019-01-22 10:16 by 127.0.0.1